Seats
Manual adjustment of provision of forward seats
Adjustment is recommended to be made as follows:
1. Longitudinal moving of a seat
Raise the handle and establish a seat in situation at which accelerator and brake pedals are conveniently reached.
2. Inclination of a pillow of a seat
Rotate the handle forward or back before achievement of the situation providing easy support of hips.
3. Seat height
Pull for the lever - lifting of a pillow of a seat
Press the lever - lowering of a pillow of a seat
4. Back inclination
Rotate the handle until the back of a seat will not be established in demanded situation. For reasons of safety situation is recommended close to vertical.
|
|
At change of situation unload a back. |
Height of head restraints
|
|
5 Release of a head restraint |
Installation is higher: put forward a head restraint up.
Installation is lower: press the button of release (5) and lower a head restraint, having pressed it from above.
Establish a head restraint so that the nape leaned on it approximately at level of eyes.
Inclination of a head restraint adjust manually. Pull for or press a head restraint in front.
Electric adjustment of provision of forward seats
Key in the lock of ignition turn in situation 1 or 2.
At an open door of the driver adjustment of provision of a seat of the driver can be made at the inserted key.
Adjustment of provision of a seat of the forward passenger can be made also at one open door.
|
|
If adjustment of provision of a seat is made from situation for lying or from far removed situation, watch that back cosmetic mirrors were closed. |
Switches in forward doors
Adjustment of provision of seats is possible, if a key in the ignition switch повёрнут in situation 1 or 2 or the corresponding door is open.
The main adjustment is recommended to be made as follows:
1. Seat height
Translate the switch behind in the arrow direction until the highest situation will be reached, at preservation of sufficient free space over the head.
2. Longitudinal moving of a seat
Translate the switch in the arrow direction until situation at which accelerator and brake pedals are conveniently reached will be reached.
3. Inclination of a pillow of a seat
Translate the switch in front in the arrow direction before achievement of the situation providing easy support of hips.
4. Back inclination
Translate the switch in the arrow direction until the demanded provision of a back of a seat will be reached. For reasons of safety it is recommended almost vertical situation. A steering wheel establish so that the hands lying on a steering wheel, were slightly bent in elbows.
5. Height of head restraints
The height of head restraints is established at adjustment by the switch so that the nape found an emphasis on a head restraint approximately at level of eyes.
Inclination of a head restraint adjust manually. Pull or press a head restraint in front.
Release and fixing of backs of forward seats
Function of assistance to landing
If the seat is in a back third of a range of adjustment of provision of seats, for simplification of landing in addition to a back leans back forward and a seat pillow. On models with electric system of adjustment of provision of seats an additional electric drive of lowering of a head restraint.
Folding of a back of a seat forward:
The handle turn forward and then cast away a back forward.
The remark for models with manual adjustment of provision of seats:
Cast away a back forward to a seat, if necessary lower a head restraint.
Otkidyvaniye of a seat back back:
Cast away a back back and press it for the purpose of fixing in the provision of movement.
On models with manual adjustment of provision of seats cast away a back back to a seat, if necessary lower a head restraint.
Heating of seats
Key in the lock of ignition turn in situation 1 or 2.
|
|
At inclusion of too large number of consumers of the electric power or an insufficient zaryazhennost of the storage battery the heater of seats can be disconnected. In this case blinks one or both control light-emitting diodes. |
At restoration of sufficient tension the heater of seats joins automatically.
The switch on the average console.
1. Button «Mode of normal heating»
2. Button «Mode of the maximum heating»
Press the button (1):
The red control light-emitting diode on the button lights up.
Mode of normal heating.
Approximately in 30 minutes the heater of seats is automatically switched off.
Press the button (2):
Both red control light-emitting diodes on the button light up. Mode of the maximum heating.
Approximately in 5 minutes automatic switching on a mode of normal heating is made.
The button (1) or (2) press once again:
Any of control light-emitting diodes does not burn.
The heater of seats is switched off.
Head restraints of back seats
If back seats are occupied, move only with the established head restraints. The risk of receiving traumas passengers on a back seat thereby decreases at failure.
1 Key
Otkidyvaniye:
Press a key (1). The head restraint leans back.
Installation up:
Cast away head restraints manually up (shooter) before fixing.
Inclination:
Head restraints can be fixed in the 2nd provisions. For this purpose press a key (1) and establish head restraints in demanded situation. A head restraint establish as it is possible closer to the head.
Height of head restraints
2 Release of a head restraint
Head restraints can be adjusted on height.
Installation is higher:
Put forward a head restraint up. If the head restraint was pushed up to the end, press the button of release (2).
Installation is lower:
Press the button of release (2) and lower a head restraint, having pressed it from above.
Removal and installation of head restraints
|
|
For simplification of installation and removal of head restraints slightly incline a seat back.
Forward seats with manual adjustment, a many-placed back seat |
Head restraint removal:
Lift a head restraint up against the stop. Press the button of release (1) and extend a head restraint.
Head restraint installation:
Head restraint establish so that the clamp of a fork was at the left in the direction of movement of the car.
Head restraint press down to fixing.
Electricly adjustable forward seat
Head restraint removal
The switch (1) move up and hold in this situation until the head restraint will not be put forward up to the end. Extend a head restraint.
Head restraint installation
The switch (1) press up within about 5 seconds.
Head restraint establish so that the clamp of a fork was at the left in the direction of movement of the car.
Head restraint press down to fixing.
By means of the switch lower a head restraint down to an emphasis and lift its top against the stop.
|